How to Power On and Begin Configuration of the Model C2

To start using your Model C2 Autonomous Material Transport Cart, follow these steps to power it on and begin configuration:

1. Locate the Power Switch:
   The red power switch is situated on the bottom front panel of the cart. Flip it to the "On" position.

2. Wait for Initialization:

   • Once powered on, the processor will initiate, sidelights will illuminate, and the touchscreen will display the boot-up sequence.
   • The initialization process can take up to 30 seconds. Please wait for it to complete before loading or moving the cart.

3. Listen for the Audio Message:
   When ready, the Model C2 will play the message: "Welcome to C2." Additionally, the status message "Ready" will appear on the top-middle of the user interface screen.

4. First-Time Use Considerations:

   • If area mapping has not been completed, the cart will default to the "Area Mapping" mode. Follow the on-screen instructions to create an initial map.
   • If area mapping is already set, the screen will display a list of available waypoints for navigation.

5. Ready to Operate:
   Select a waypoint or mapped location from the displayed options, and the Model C2 is ready for autonomous deliveries.

Tips for Optimal Use:

• Ensure the robot is not interfered with during initialization.
• Maintain a clear area around the Model C2 to avoid sensor interference.

For further assistance, refer to the Getting Started section of the user manual or contact Quasi Robotics' technical support at support@quasi.ai.